S-7108 Pole-tap to Pole-tap DC Cable
› Connect with 5.5/2.1mm pole-tap output power source
› Output DC via another 5.5/2.1mm pole-tap connector
5.5/2.1mm Pole-tap to Pole-tap Cable
S-7108 has 5.5/2.1mm pole-tap connector for
both ends, which is used to get DC power from
S-7200 series adaptor or SWIT DV batteries
with pole-tap DC output, and supply power to
the devices with pole-tap DC input.
Power connector (A) | 5.5/2.1mm 2-pin pole-tap |
Power connector (B) | 5.5/2.1mm 2-pin pole-tap |
Cable length | 0.6 meters |
MSRP
$8222
MSRP
$8222
MSRP
$8222
We provide a 1-year conditional warranty, and the following damages/issues are not covered under warranty:
(1) Any damage or malfunction caused by use, maintenance, or installation not in accordance with the User Manual's instructions, including improper insertion into camera or power device, incorrect polarity connection, cable bending beyond recommended radius, or disassembly/repair without authorization of SWIT.
(2) Any damage caused by using third-party power supplies, batteries, chargers, or accessories that do not comply with the recommended electrical specifications, or by operating the product beyond its rated current, voltage, or load limits as stated in the technical specifications — including but not limited to melted insulation, burnt contacts, internal short circuits, or blown fuses resulting from over-current, over-voltage, or excessive load.
(3) Any damage caused by irresistible factors (such as earthquake, fire, lightning, flood, etc.) or human factors including crushing, pulling with excessive force, pinching, dropping, or improper storage in contact with sharp or heavy objects.
(4) Any damage or malfunction not caused by the product's design, workmanship, or manufacturing quality — including normal wear and tear of cable jackets, connector plating, strain relief boots, or contact spring tension.
(5) Physical damage to plugs, sockets, connector housings, locking tabs, or terminal pins resulting from violent use, improper insertion/removal, forced connection with incompatible ports, or pulling on the cable body instead of the connector is specifically excluded from warranty coverage. This includes bent, snapped, or cracked plug shells, broken latch mechanisms, separated solder joints from excessive strain, and deformed pin contacts.
(6) Electrical damage (including melted connectors, scorched dummy battery casings, deformed DC jacks, or cable insulation shrinkage) that is determined to be caused by connection to a power source or device exceeding the product's specified voltage, current rating, or duty cycle shall not be covered under this warranty.
